| Double skin partitioning is an alternative product for installations where a smooth interior finish is required; works offices, clean rooms and storage areas for chemicals or food products. |
|
Panels are constructed from 25.4 x 42 x 25.4 x 1.2mm (18g) cold rolled channels panelled both sides with 0.8mm (21g) CR4 mild steel sheet with 30mm Rockwool mineral fibre infill and are joined together using an 'H' section, making the installation very similar to that of composite partitioning systems. Panels are available in solid, half-glazed, solid/glazed/solid or borrowed light elevation. |
|
 DOUBLE SKIN PARTITIONING |
|
INTERIOR VIEW |
| 1 |
Standard Half-Glazed Panel |
 |
| 2 |
Intermediate Mullion |
| 3 |
Door Unit |
| 4 |
Top Channel |
| 5 |
Wall Channel |
| 6 |
Floor Channel |
| 7 |
Obscured Glass |
| 8 |
Corner Section |
| 9 |
Standard Solid Panel |
| 10 |
Three Way Junction |
| 11 |
'H' Post Joining Section |
|
| |
STANDARD PANEL SIZES |
 |
| |
| Height |
2400, 2700, 3000mm |
| Width |
1000mm |
| Dado height |
1200mm |
| Thickness |
47mm |
| A range of infill and special panels can be supplied to maintain final dimensions. |
|
|
|
| |
MULLION SIZES |
|
| |
50mm x 50mm x 2mm
[up to 2700mm] |
80mm x 40mm x 2.5mm
[2700mm and above] |
| All two-way (intermediate) mullions have base plates for floor fixing. Knee braces and/or ladder mullions may be fitted for extra stability and strength eg on clear access doors. |
|
|
|
| |
STANDARD DOOR MODULE SIZES |
|
| |
| Steel or timber |
| |
Height |
Width |
Side
Hung |
2022mm
plus overpanel to partition height |
900mm
|
| Double Doors |
2022mm
plus overpanel to partition height |
1740mm
|
| Sliding Doors |
to suit customer's requirements |
| Doors can be supplied with or without vision panels. A full range of non-standard door types, i.e. full-height leaves, clear access modules or hospital type leaves are available to order. |
|
|
|
| |
GLAZING |
|
| |
Glass is mounted on foam strip and held in place by steel glazing beads, 6mm toughened, 6.4mm laminated and 6mm Pyroshield are supplied as standard. However other types of glass and Perspex may also be fitted as required. Double glazed panels may be supplied using 6mm toughened to the outer face and 4mm toughened to the inner face, fitted into a plastic two-piece double glazing section. |
|
| |
PAINT FINISH |
|
| |
All panels are electrostatically powder coated in the following standard colours;
Grey 10 A 07, Grey 00 A 05,
Sandstone 08 B 17, Stone 10 B 17.
Special colours (over 100 in stock) are available at extra cost. |
|
| |
|
|
| |
ACCESSORIES |
|
| |
A comprehensive range of accessories, including drop-down and sliding hatches, louvres, vents and locking systems are available to order. |
|
|
